mervinrs, this could be a multitude of things. Remote not working and red light flashing, Re: Remote not working and red light flashing, HDMI settings a reset after cable unplugged, samsung tv-how do I get my dish remote volume buttons to work on the tv everything else works, Samsung Series 8 75' TV: SmartThings App doesn't work during setup + TV remote doesn't work. Everything has worked perfectly for over a year. Although Samsung have produced some of the best smart TV‘s in recent years, there is a common problem with a minority of their models. I did that, it re-linked with the TV and then continued its 'always on' pattern. Try pressing the back button + the UP button at the same time for 10-20 seconds. The first solution I found, to take the batteries out and hold down the power button while replacing the batteries, is not correct. Samsung had several power supply's that came from the manufactor that installed on the circuit board 10 volt capcitor's instead of 12 volt capcitor's. Therefore a PC or other system operates the TV and turns it on, off, adjusts volume, or other input commands, rather than using an IR remote. The red power light keeps blinking rapidly and the sound is a … read more Samsung TV unresponsive to remote.Sometime after turning the set on (normally a few minutes, sometimes less, sometimes more), the TV becomes unresponsive to the remote.The red light on the set flashes, so a signal is being received, but the TV does not respond to … The TV was on when I did this. I have read through the posts and tried everything, yet i cannot get any of the functions to work. I tried resetting the remote, repairing it, same thing. 12:09 AM, Hello, I am having the same problem. Samsung TV Not turning On But Red Light Stays still Samsung TV Not turning On But Red Light Stays still. The blinking red light issue is something no Samsung TV owner wants to see. If the flashing light is interrupted, it automatically changes the channel. I am guessing the remote has some sort of internal fault, but wanted to check here first. The key is the red standby light, a little red light at the edge of the TV that you aim the remote at. My Samsung remote suddenly stopped working and I tried everything including the whole check the … If it seems like it's pressing buttons by itself, it may actually be that your TV's controls are dirty. Does the TV remote work OK, by pointing it at the TV, with the remote sensor unplugged? 06:48 PM. This issue is usually caused by a bad power supply but it can also occur in some cases due to a glitched HDMI link. My remote is showing the light but the Samsung smart TV in not responding.

Red light blinking samsung tv